Using scissors, made a slit that extends about halfway down this cylinder. Trim the other paper to a strip about 1 ½” long - curl this rectangle into a cylinder and stand it on end. Use the paper from one to roll a moderately thick blunt with a filter at one end.
![pinner joints pinner joints](http://4.bp.blogspot.com/-e_hi2Ehg3ZY/VDaYcOwWNVI/AAAAAAAAAOg/JKS50XExuoo/w1200-h630-p-nu/Joint_Varieties.jpg)
Empty out two blunt cigars by slitting them down the middle. This one isn’t technically a joint but it looks like something Gandalf would smoke, which should make it worth trying. Seth Rogen expertly and patiently shows you how in this video. Then just poke a small hole (no need to bore it any wider than the width of the needle) through either side of the small pinner this will allow the smaller joint to burn at the same rate as the larger one. You can cut off the glue strips off of spare papers to seal up the places where the two joints meet. Then carefully push the smaller joint through the hole, forming a cross.
![pinner joints pinner joints](https://i.pinimg.com/originals/ee/54/c4/ee54c4ad9f97fd8b31bb791de175f7a4.jpg)
Slowly rotate the needle, working it so that the hole becomes large enough to accommodate the pinner. Now take a needle or any thin, sharp implement and poke a hole three-quarters of the way down the length of the larger joint. For the second, the horizontal arm of the cross, roll up a small pinner - without a filter and twisted off at both ends. It should be thick enough for you to slip a smaller joint right through the middle. Roll it up into a thick cylinder (rather than a cone) with a filter in one end.
![pinner joints pinner joints](https://www.exit15.com/image/cache/catalog/food/pinnertest-box-600x315.png)
For the large vertical arm of the cross, use a wider paper. Vaguely sacrilegious? Maybe to some, but this weed Bible study group in Denver would probably appreciate cross-shaped joints.